ISUZU D-MAX 2007-2011

PROGUARD ROLLBAR-SILVER

TECHNICAL DETAILS

  • Manufactured from Polyurethane covered steel body combined with specially painted 76mm. steel tube.
  • Installation of the product is made from 8 different points on the car, providing strong and durable connection.
  • 76mm.steel tube bended with the same slope of the roof of car specific to each model of car and metallic colored.
  • Thanks to its wide polyurethane main body, it provides elegant visibility
  • It is possible to install different apparatus on the product such as foglight, warning plate and etc…
  • Can be applicable to all brands in Pick-Up models
  • Production is made according to ISO 9001-2008 TUEV standards.

USER MANUAL

USER MANUAL

I.Disclaimer for Voyager Products

Voyager products are designed to be sold as decorative accessories, and should not be relied upon
as protection for both passengers and vehicle. The buyer assumes all risk and liability whatsoever resulting from the use of said products. There are limitations to the severity of impact that the products sold herein can withstand and the products are not a substitute for safe and careful driving.

II.Care & Cleaning

Although products are made with high quality raw materials which are designed to provide maximum weathering protections, they may be affected negatively by environmental conditions. By following regular care and maintenance it will ensure maximum level of protection and good external appearance. Weekly periodic cleaning is recommended depending on the weather and environmental conditions.

Care and Cleaning Guidelines

  • Rinse the product in order to remove the dirt and dusts stuck on the surface with warm water.
  • Use a soft, dampened sponge or cloth to clean. Never use abrasive material like a bristle brush or scouring pad.
  • The preferred cleaner is one that does not contain chlorine, such as acetone, methyl alcohol, and mineral spirits. Use neutral cleaner cleaners compounded from phosphates, alkalis such as liquid soaps and mild detergent. Do not allow cleaners to sit or soak on the product. Always test your cleaning solution on an inconspicuous area on the product before applying it to the entire surface. These can be used with warm water, bristle brushes, sponges, or clean cloths.
  • Rinse the surface completely with water immediately after applying cleaners and than dry it by wiping with soft cloths to prevent streaking. Special care should be taken to remove any traces of cleaner from edges and joins

Warnings

  • For painted steel surfaces synthetic soft cleaning materials sigh as liquid soap are recommended. Avoid allowing surface to scrape against hard or sharp surfaces. Aggressive alkaline or acid cleaners must never be used on painted surfaces.
  • Never use petrolium based cleaning materials (benzine, gasoline, thinner, etc.. ) on polyurethane surfaces.
  • Be cautious about using chemical solvents, caustic or abrasive cleaners (scouring powders, steel wool, abrasive polishes, etc.) as they may permanently scratch painted surface; painted surfaces will be permanently damaged. Test solvent first if the surface is painted to be sure it doesn't also remove the paint
  • Do not use a metal scraper or abrasive pad. Excessive abrasive rubbing should not be used since it could damage the surface.

III.Transportation & Handling

  • The products should be delivered with their original packaging.Although the packages are prepared with high resistant raw materials handling and transportation of the products should be made in carefull. They should not be thrown quickly, bump to each other.
  • The products should be submitted after the package has been opened and checked. If there is any bend, scracth or any of damage on the product damage report should be prepared with the responsible person from the trasporter company and than they should be submitted.
  • The damages during handling or transportation are not covered.

IV.Installation

Installation should be made according to installation manual.

Installation Cautions

  • Product is delivered in 3 parts, first combine the product according to the installation manual.
  • After the product is ready, put the product on the rear chassis, check the position of the product on the car.
  • Product is installed to the car from the screw points on the connection parts.